sonnenblen.de - Das unabhängige Sun User Forum
Hardware => Sun SPARC => Thema gestartet von: jmar83 am 08. September 2015, 23:18:10
-
Hallo zusammen
Weiss jemand wie man eine Sun Ultra 45 zurücksetzt wenn an kein Konsolenkabel hat?
Irgend eine Tastenkombination?
Danke für die Tipps.
-
Hallo jmar83,
ist eine Tastatur, ggf. auch Monitor angeschlossen?
Wenn ja, mal nach dem Anschalten die Tastenkombination <Stop>+<A> betätigen.
Nun frag ich mich auf WAS du die Ultra 45 überhaupt "zurücksetzen" möchtest? Die Default-Paramaeter des NVRAM? Dann...
ok set-defaults
Quelle: http://docs.oracle.com/cd/E19127-01/ultra25.ws/819-1892-12/nvram.html
Gruß, escimo
-
Hallo escimo
Die Frage ist nur für den Fall des Falles... meine U45 läuft soweit problemlos.
Was aber wäre wenn ich eine U45 hätte bei der das output-device nicht auf "screen" wäre, und ich auch kein Nullmodem-Kabel hätte?
Mit dem OBP 4.30.4 werden auch andere Tastaturen unterstützt, ich glaube "Stop-A" entspricht dort "Shift-Break" (oder Ctrl-Break, ich weiss es nicht mehr genau...)
Bei älteren Systemen konnte man Stop-N beim hochfahren drücken, das was entspricht "Stop-N" auf einer "normalen" Tastatur? (Wohl auch erst ab OBP 4.30.4 unterstützt)
-
Oder ist der default-Wert für das output-device gar die serielle Konsole? ;)
-
Laut Doku, kann man das Verhalten von <Stop>+<N> simulieren über den Hauptschalter auf der Vorderseite:
10.5.2 Stop-N Equivalent Key Sequence Procedure
For older Sun systems, issuing the Stop-N key sequence upon startup resets workstation configuration variables. The Sun Ultra 45 and Ultra 25 workstations use a Sun Type-7 USB keyboard. It is not possible to issue a Stop-N key sequence with a USB keyboard. By the time the USB keyboard driver is loaded, the interval to use the Stop-N key sequence has expired. Instead, use the following procedure to reset your workstation configuration variables. This procedure puts the Sun Ultra 45 or Ultra 25 workstation into a Safe NVRAM mode.
10.5.2.1 Resetting the NVRAM Temporarily
1. Power on the workstation and wait until the front panel Power button LED begins to flash.
2. Quickly press the front panel Power button twice (similar to the way you would double-click a mouse).
Quelle: http://docs.oracle.com/cd/E19127-01/ultra25.ws/819-1892-12/nvram.html#pgfId-998928
-
Vielen Dank!!