Booting from: sd(0,0,0)vmunix
SunOS Release 5.4 Version Generic_101945-27 [UNIX(R) System V Release 4.0]
Copyright (c) 1983-1994, Sun Microsystems, Inc.
Parity error reported at 0xff140ff0, actual address is 0xff140ff0.
Parity Error, ctx = 0x0, virt addr = 0xff140ff0
pme = e3003fff, phys addr = 3fffff0
Parity Error Register d4<ERROR,MULTI,CHECK,ERR08>
bad module/chip at: ?
parity recovery: more than one error
System operation cannot continue, will test location anyway.
parity error at ff140ff0 with pattern aaaaaaaa.
parity error at ff140ff0 with pattern 55555555.
parity error at ff140ff0 with pattern 1010101.
parity error at ff140ff0 with pattern 2020202.
usw ...
das naechste mal wars dann panic: mmu_getpmg
mal kein parity error ...
funny
ich dreh noch durch =)
Ich koennte kotzen was zurhoelle ist das nun wieder ?
NetBSD laueft doch auch einwandfrei
Siehe:
# dmesg
NetBSD 1.5.2 (INSTALL) #0: Wed Aug 22 05:51:09 CST 2001
toor@proxima:/usr/src/sys/arch/sparc/compile/INSTALL
total memory = 65444 KB
avail memory = 61156 KB
using 128 buffers containing 512 KB of memory
bootpath: /fd0
mainbus0 (root): Sun 4/65
cpu0 at mainbus0: MB86900/1A or L64801 @ 25 MHz, WTL3170/2 FPU
cpu0: 64K byte write-through, 16 bytes/line, sw flush: cache enabled
memreg0 at mainbus0 ioaddr 0xf4000000
clock0 at mainbus0 ioaddr 0xf2000000: mk48t02 (eeprom)
timer0 at mainbus0 ioaddr 0xf3000000 ipl 10 delay constant 10
auxreg0 at mainbus0 ioaddr 0xf7400000
zs0 at mainbus0 ioaddr 0xf1000000 ipl 12 softpri 6
zstty0 at zs0 channel 0 (console i/o)
zstty1 at zs0 channel 1
zs1 at mainbus0 ioaddr 0xf0000000 ipl 12 softpri 6
kbd0 at zs1 channel 0
ms0 at zs1 channel 1
fdc0 at mainbus0 ioaddr 0xf7200000 ipl 11 softpri 4: chip 82072
fd0 at fdc0 drive 0: 1.44MB 80 cyl, 2 head, 18 sec
audio at mainbus0 ioaddr 0xf7201000 ipl 13 not configured
sbus0 at mainbus0 ioaddr 0xf8000000: clock = 25 MHz
dma0 at sbus0 slot 0 offset 0x400000: rev 1
esp0 at sbus0 slot 0 offset 0x800000 level 3: ESP100, 25MHz, SCSI ID 7
scsibus0 at esp0: 8 targets, 8 luns per target
le0 at sbus0 slot 0 offset 0xc00000 level 5: address ff:ff:ff:ff:ff:ff
le0: 8 receive buffers, 2 transmit buffers
bwtwo0 at sbus0 slot 3 offset 0x0 level 7: SUNW,501-1419, 1152 x 900
bwtwo0: attached to /dev/fb
scsibus0: waiting 2 seconds for devices to settle...
sd0 at scsibus0 target 0 lun 0: <SEAGATE, ST34520N, 1444> SCSI2 0/direct fixed
sd0: 4340 MB, 9006 cyl, 4 head, 246 sec, 512 bytes/sect x 8888924 sectors
md0: fixed, 1360 blocksroot on md0a dumps on md0b
Leider hab ich die 4gb hd noch nicht richtig lauffaehig gebracht daher wollte ich derweile die alte HD benutzen mit Solaris drauf :/
